Can you siphon gas out of newer cars

All cars have a fuel rail , usually, these are right above the injectors and all of them have a pressure release valve that is protected by a cap.

This is similar to the pressure release valve to the tires, and you can use the same tools to get the cap off. Once you have screwed the cap off make sure to remove the valve, this is a small object so make sure you do not lose it, or else the car will not work after.

If you have some mechanical siphon you could try to siphon out the gas, but odds are that you will not be able to do it, the same is for siphoning manually. Here comes the tinkering part, once you have found the fuel pump relay , generally these are either right under the dash or under the hood.

Once you have found it, remove it and you will notice that the relay has several ports. Now all you have to do is to put a piece of wire back in the fuel pump fuse sucket from where you picked out the fuse in such a way that the wire goes in both of the negative and positive ports.

When you are doing this make sure that the car is not running as you might get electrocuted. Once the wire is in place this will allow the fuel pump to work properly if you do not take out the fuse and replace it with the wire the car once started will stop in a matter of seconds and you will not be able to siphon out any gas. If it is not working you have probably not placed the wire in the right slot and you probably have triggered the onboard CPU which will stop the fuel pump from working after a few seconds.

All modern cars have a fuel pump, and this is what you are going to use to siphon out the gas. If you have set up the wire correctly then the fuel pump should also work as intended. Make sure that before you start the car is that you have already attached a hose to the fuel rail which leads into a gas canister. It is very important that this hose fits the fuel rail and it is not loose as once you start the car the fuel pump will start pumping fuel through the fuel rail and into your gas canister through the hose.

For this method to work you have to make sure that the gas tank from which you are siphoning out the gas is on a higher elevation than the gas tank which you are feeding. Notice I did say gas tank and not the actual car should be on a higher elevation, as some cars have a higher center of gravity and their gas tanks are also on a higher elevation. In case you own an SUV and try to siphon gas out from a smaller car then it is very important that you actually position your SUV on a lower elevation, this way gravity will work for you and not against you.

Thanks for the info! Hmm, that was interesting. You could just walk away and come back later. Having a longer hose, and putting the gas can all the way on the ground, would help because it would give more gravity to the situation. Oh, and the hardware store is full of cheap hoses of all different diameters.

I just bought one for my aquarium protein skimmer. The old one got aged and stiff. Though the experience of having gas stolen from my gas tank while I had the vehicle in storage, I found out that there is a connection to the gas tank of a Odyssey that can be disconnected to drain the gas tank. How did you drain it? Does it have a capless gas tank, thos have anti siphon filters. The pipe that connect to the fuel injector is easy to disconnect safely. You need to put the container close, which mean above the level in the gas tank.

The gas pump will run for 2 seconds. Turn key to off, then run, you get another 2 second worth of gas. Repeat until you fill your container. A more efficient method would be to identify the relay for the fuel pump, remove it from the socket and insert a wire between the pin that correspond to the relay contact. The fuel pump would work continuously.

Be very careful doing that. All fuel pumps are lubricated by the fuel itself. I taper the end of the hose an d still having a problem. I think Fords use something like a butterfly system instead of the ball. That may be the issue, call parts store and ask what part is there. Good luck! Well I just had my gas stolen and I am not happy that it is so easy to do and freely discussed, I have to live on a very small SS check. I own a ford freestar.

Would like to siphon gas from vehicle in a most convenient manor. Manufacturers have special tools called fuel drain hoses to get past the fuel tank check valve. For example a Chevrolet Equinox requires GM Is it bullshit? View Quote View All Quotes. Quoted: Quoted: Quoted: Your 02 Ranger should have a fuel pressure test port on the fuel rail. You can hook a hose up to this with the correct fitting and jumper the fuel pump relay to kick the pump on.

Or with the proper tool you could disconnect the fuel supply line to the rail or filter on the frame rail and connect a hose there instead. Quoted: But it should have come with a funnel that bypasses the gas nozzle break.

I don't know if you can push tubing through that or not? Quoted: Your brilliance is not apparent in your words.

Neighbors car with a hammer and screw driver. Quoted: All recently manufactured vehicles have ball valve that prevents fuel spills in a rollover. They have stills in NC Simply build a small fire underneath the gas tank, and clamp a condensing device over the fill nozzle. Quoted: Yep. Thats why cars made for the US market won't run in Australia without removing that ball. Quoted: Quoted: It's a ball of some type. What it does is if the car flips over and lands on the roof it prevents gas from spilling out.

It's a safety device put in all newer cars and trucks. Throw a bucket under the gas tank and loosen the bolt to drain it. Quoted: I live in central N Carolina. It's unlikely that I will need generator gas, but it's never too late to ask questions.

Quoted: Your 02 Ranger should have a fuel pressure test port on the fuel rail. Screw driver and a hammer is all you need Remove screwdriver, and the gas will just flow out. It's probably better to "siphon" gas using this method on somene else's car though. Quoted: Disconnect the filler neck from the tank and siphon directly from the tank.

Had to do that with my Mustang to replace the fuel pump. Quoted: Not true. Some Ford vehicles have "ball" in the filler neck, but you CAN siphon gas out of a lot of modern vehicles - I have confirmed this personally. A lot of vehicles have a somewhat twisted path between the filler neck and the gas tank, with accordion bellows hose often used for part of it - Which makes it difficult to use a traditional rubber siphon hose.

What often works better is thin, semi-rigid plastic tubing similar to fridge icemaker water line - The small diameter handles sharp turns better, and the rigidity makes it easier to control the direction as the hose is inserted. Another trick is to cut the end of the hose at a very sharp angle - Allows you to rotate you siphon if the end gets hung up on an accordion rib inside the filler hose.

Some Ford vehicles have "ball" in the filler neck, but a lot of other modern cars and trucks don't. You CAN siphon gas out of a lot of modern vehicles - I have confirmed this personally. Quoted: Screw driver and a hammer is all you need Attached File. Buy a selection of fuel line disconnect tools; select appropriate tool for the target vehicle; release lock and drop filter; place container under filter end; turn ignition key "On"; collect gas.

Reinstall fuel filter. Quoted: I will do that. BUT, we lived through Hugo in Charlotte. No power for 13 days. Gas was hard to find for awhile. I use Alcohol free in my truck. Perfect generator fuel, and a lot of it. Quoted: It's a ball of some type. Quoted: Throw a bucket under the gas tank and loosen the bolt to drain it.

Quoted: Cool, show me a recent vehicle so configured. Quoted: Quoted: Not true. Quoted: Yeah Quoted: Quoted: Not sure, but now that you say that my f came without a gas cap. Disconnect the line from the fuel filter. Turn key on